I have 4 x Athom Plug V2 (AUS). Initially, 3 of them worked perfectly and 1 worked fine but would not show the power readings, on the Tasmota web config page, the units that work show Athom Plug V2 and the one that works but without any of the readings shows Sonoff basic.
I didn't think too much of it(maybe one unit was different to the others) since I didn't need all to read power. But since I have reconnected 2 of the units that had been off for a while I now have 2 units acting like this and 2 that work fine. I have tried re flashing firmware, currently 12.4.0 but it made no difference.
Can someone let me know how to get them all working the same, with power readings?
I have the exact same issue. However mine went to 'Basic Sonoff' after I ran a system factory reset. And cannot now seem to be able to reselect in config 'Athom Plug V2'.? Is there a way to get this back?