ATHOM Open Hardware Forum

Hi, I recently purchased a 4ch relay and intend to use one channel as garage door controller. Can you please advise how do I change the HomeKit device type and plug-in installation to expose it as garage door? Much appreciated.

Hi Athom team, I have been using VWLED controllers and GU 10 bulbs for some months now and they are fantastic. However, I have a whole load of MR16 12V bulbs, but I would love to replace them with pre-flash WLED one. Tanner team please consider introducing a MR16 12V version? They do seem to already be bulbs that have the BSP8266 chipset, so technically it should not be too big a challenge. like this one MR16 Smart LED Light Bulb 12V RGBCW Dimmable Lamp Siri Voice Control 5W Spotlighting Color Changing https://a.aliexpress.com/_mq9F2HG

Hello I'm trying to reset to factory defualts the Athom presence sensor, over the ESP menu configuration I alreday upload the default config presente in this site: https://devices.esphome.io/devices/Athom-Human-Presence-Sensor With this change: switch: - platform: template name: "mmWave Status" id: "mmwave_sensor" internal: true entity_category: config optimistic: true restore_mode: "RESTORE_DEFAULT_ON" turn_on_action: - uart.write: "sensorStart\r\n" turn_off_action: - uart.write: "sensorStop\r\n" - platform: factory_reset name: Restart with Factory Default Settings But I still not able to have the default factory reset done once the device is not asking me to configure the access point again Can you please let me know how to performed the reset once the button or the web app is not performing this factory defaults ? Thank you and best regards