I've been having trouble understanding how to flash or load the WLED firmware onto my Athom E27 7W Bulb that I purchased from Amazon. It came pre-flashed with Homekit, but I've seen in other posts you can't load WLED onto it, is that correct or how would I do that? Another option I saw was to open the bulb and get to the ESP chip to flash it, but I can only get the diffuser off and can't seem to take off the diode board, any tips? I also bought a USB to serial terminal, because I saw that you have might have to solder to the points to connect to it. I'm unsure about this as well. Any help is greatly appreciated! Thanks
E27 is the base size. Specifically, which bulb did you buy?
I have never done it, but if Homekit has an update process, you could update it to the WLED binary.