I have these analog RGB lights that are hooked up to the new WLED RGBW Light Strip Controller and I can't seem to get the lights to come on. I have a voltmeter reading 12V at the light itself, but the lights are not on. I have tried everything on the WLED settings and I am lost on which direction to go. I can directly apply the + / - lines to the light from the dc power and I can get the lights to flicker, so I know I have the correct voltage. What could be going on?
top of page
Um zu sehen wie dies funktioniert, öffne deine veröffentlichte Website.
Analog RGB with WLED RGBW Light Strip Controller
Analog RGB with WLED RGBW Light Strip Controller
4 Kommentare
Gefällt mir
Comments (4)
bottom of page
Try this firmware, pay attention to the GPIO settings
https://drive.google.com/file/d/1Zsu1quUVOV58tnyU2_cNf8JiSBHHVBXs/view?usp=share_link