I recently purchased a LS5050C-TAS, RGB LED Strip Controller with Tasmota Firmware. When I attempt to dim down near the bottom of the PWM range, I get an incredible whine out of the LED strip. I don't have this problem when powering from other controllers. Is there anything that can be done to eliminate the whine from the LEDs?
top of page

Um zu sehen wie dies funktioniert, öffne deine veröffentlichte Website.
Comments (5)
bottom of page
With this site - https://beton.ua/slots-games , I can play my favourite slot games anytime I want. The interface is simple to use, the games are exciting, and the bonuses add extra fun to the experience. I have already discovered many new slots and won some money, which makes it one of my favourite online casinos.
I've encountered similar PWM whining issues with LED strips before! The frequency might be too low, causing audible noise. Try adjusting the PWM frequency in Tasmota's console using PWMFreq command - higher frequencies (like 1000Hz) often eliminate the whine. Sometimes when I'm troubleshooting electronics late at night and need a mental break, I play Block Blast for a few minutes to clear my head before diving back in. Have you checked if your power supply is adequate too?
Geometry Dash Lite is a popular mobile game developed by RobTop Games. As a free version of the full Geometry Dash game, it offers players a fast-paced, rhythm-based platforming experience. Though the game may look simple at first glance—with its colorful graphics and one-touch gameplay—it challenges players with levels full of spikes, moving obstacles, and tight geometry dash lite jumps. Despite this, many players consider Geometry Dash Lite relatively easy, especially when compared to the full version and user-created levels found in Geometry Dash and Geometry Dash Meltdown.
Very disappointed in this controller. After being powered on for a few minutes at max power it starts to randomly blink. And I'm not even using all 3 channels, only two of them.
I think this might have something to do with the PWM frequency that I am using. Is there a specific frequency that you recommend based on the mosfets being used?